Official Raspberry Pi Power Over Ethernet PoE HAT Add-on Board

Regular price $43.95

The Raspberry Pi PoE HAT powers a Raspberry Pi 3 Model B+ via an Ethernet cable. Power-sourcing equipment is required on the Ethernet network. The PoE HAT The Raspberry Pi Power over Ethernet HAT is a small accessory for the Raspberry Pi computer. It can only be used with the Raspberry Pi 3 Model B+ (launched March 2018). The PoE HAT allows you to power your Raspberry Pi using Power over Ethernet–enabled networks; for this product to be used, the network it is connected to needs to have power-sourcing equipment installed. Specifications - 802.3af PoE - Fully isolated switched-mode power supply - 37–57V DC, Class 2 device - 5V/2.5A DC output - 25mm x 25mm brushless fan for processor cooling - Fan control Supplied with this product -Raspberry Pi PoE HAT -Mechanical spacers Other hardware needed (but NOT included) - A Raspberry Pi 3 Model B+ - An Ethernet cable - Power-sourcing equipment for a 802.3af Power over Ethernet network Connecting your PoE HAT to the Raspberry Pi - Before installing the PoE HAT, you must attach the supplied spacers in the four corners of the board - Then connect the Raspberry Pi PoE HAT to the two 0.1” headers (40 + 4) that are fitted on the Raspberry Pi -Once the PoE HAT board is connected, you can power the Raspberry Pi through its RJ45 network connector Disconnecting your PoE HAT - Take care when separating the HAT from the Pi - Pull evenly so that it detaches from all the pins at the same rate; do not pull one end of the connector off before the other

  • The PoE HAT allows you to power your Raspberry Pi using Power over Ethernet–enabled networks
  • Requirement: Raspberry Pi 3 Model B+, An ethernet cable, Power-sourcing equipment for a 802.3af PoE network
  • 802.3af PoE; Fully isolated switched-mode power supply
  • 37–57V DC, Class 2 device; 5V/2.5A DC output
  • 25mm x 25mm brushless fan for processor cooling; Fan control